2018-1/29-2/11 Upper Cabinet Carcass and Vent

I created an upper cabinet that I built in-place, above the kitchen cabinet area.

First I put up a couple of wooden 2×2’s to act as the reference points, and beginning of the skeleton. Then came the end pieces and divider pieces, which would add stability and separate the spaces for the cabinets.
Total overkill on the support, but I don’t want this falling on anybody, especially while the bus is in motion.
The dividers were cut around the supports above, then more frame was added to them.
Installed the hood vent a few days later. Took some craftiness to adapt it to the bus, but it worked out well.
Vent Hole for the hood.

Previous | Photos Home | Next